painting clamp

Rotary clamp (360 degrees) for painting miniatures. The basis is a Shrabkugel vice and a clamping chuck is added to it. The sphere is made hollow, and I used plasticine to weigh it down. At an angle of more than 45 degrees from the vertical, the vice can fall into a horizontal position, a possible way out of this is to use a rough wall in the slicer settings. A second version of the holder was also made, where the stops are set at different angles. In the lower crosspiece, recesses are left for anti-slip feet, I used a silicone baking mat, 4 squares of 20x20 mm are needed.