Palette 2 Stand

Here is a stand that I designed for my Palette 2. WARNING!!! I just finished printing the last piece so it has not been fully tested, but it seem sturdy enough. My Palette 2 bypass is built into both side, and my spool holder fit underneath (links for both are below).

https://www.thingiverse.com/thing:4823405
https://www.thingiverse.com/thing:4606777

There are STL for three screws. These are based on the thread offset. And the size you choose will depending on your 3D printer. Screw1 has the smallest offset, will be the largest part and will have the most snug fit if it fits. I would start with that and use the others if it does not fit.

I mirror all of the parts so the left side has left hand threads.