Palette 2 Stand - Upside Down

I really wanted to place my new Palette 2 Pro on top of my printer enclosure. The problem was that I wanted the filament to be positioned behind the Palette 2 so that I could easily access the Palette 2 screen. Having seen that the firmware update allows the Palette 2 screen to be rotated 180º, I decided to remix the Palette 2 stand so that the Palette 2 could be placed standing up, but upside down.

When you mount the stand upside down like this, it wants to slide right off, of course. But, fortunately the fine folks at Mosaic added a hole on each side of the back of the Palette 2. So, I added a matching hole to the stand. I used an M3x8 screw on each side, which is perfectly tight for the holes. I would advise only using screws of 6mm or 8mm--not any longer for fear of hitting something inside.

Finally, if you like, you can take the rubber feet from the stock stand and use them on this one.

Parts Required:

2 - M3 6mm or 8mm screws