Thingiverse
PALZero
von ajcraig
210
Downloads
223
Likes
2
Makes
With plenty of love shown for the North American SNES for raspberry pi cases and the more aesthetically appealing (imo) PAL version being left behind, I decided to model one to suit a Pi-zero with working buttons and front facing USB ports.
It's a very easy print but requires some soldering for the USB ports and network card to work, I have written a draft guide for this but made a mistake with the GPIO wiring for the buttons. I aim to update this before Christmas 2016. I have uploaded all the images anyway in the hopes that you can see the general idea and make the corrections as you go. Otherwise simply leaving the buttons disconnected will work for the time being.
My XYZ orientation screws up the STL export so you will need to re-orientate the parts before slicing.
Supports are required for the top & bottom shell and I recommend removing any supports under the rear vent if your slicer supports it.
It's a very easy print but requires some soldering for the USB ports and network card to work, I have written a draft guide for this but made a mistake with the GPIO wiring for the buttons. I aim to update this before Christmas 2016. I have uploaded all the images anyway in the hopes that you can see the general idea and make the corrections as you go. Otherwise simply leaving the buttons disconnected will work for the time being.
My XYZ orientation screws up the STL export so you will need to re-orientate the parts before slicing.
Supports are required for the top & bottom shell and I recommend removing any supports under the rear vent if your slicer supports it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
