Panacast 2 - 180 Degree Camera

I needed to have a "dummy" Panacast 2 for a project so I created this model.

It is fairly accurate, I used micrometer to measure, things may be off by a few tenth of a mm here or there. Should be good enough for fitment of mounts and such or if you needed to give a vendor or customer a accurate idea of the camera size.

Took about 1.5 to print at settings listed. Print quality is pretty rough, only need to very design printability and use for quick fitment check.

**NOTE:** I used a SketchUp Model for the basis of the initial build. It was downloaded from SketchUp's 3D Warehouse. Original was created by [NewEraTechnology](https://3dwarehouse.sketchup.com/by/neweratechnology?nav=models)