Thingiverse
Panasonic ER2302 Switch
by qrti
0
Downloads
3
Likes
0
Makes
After my Panasonic ER2302 razor had a hard landing on the floor, only a fragment of the power switch was left. After some caliper work and blender construction I printed a new one. Next I ...
- fixed some small pieces of paper around the remnant switch (to avoid glue flowing into the razor)
- placed the plate (guiding bar to bottom), above the cover paper
- filled some two component glue inside the plates opening
- filled some glue inside the knob
- placed the knob on the plate
- waited some time
- teared and cut the protruding paper
- ready, works like a charm
- fixed some small pieces of paper around the remnant switch (to avoid glue flowing into the razor)
- placed the plate (guiding bar to bottom), above the cover paper
- filled some two component glue inside the plates opening
- filled some glue inside the knob
- placed the knob on the plate
- waited some time
- teared and cut the protruding paper
- ready, works like a charm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
