PancakeBot Version 1 & Version 2 Gantry Leg

This is a two part piece for the supporting leg of the PancakeBot Gantry. It fits snug (it has to) and you need an 8mm ID by 8mm width bearing, the type you use for Fidget spinners or Roller Blades.
Print the parts out separately and use a small wood screw about 5 mm in length to connect the pieces and secure them. The fit is rather tight so it may not need a screw.
When printing, I recommend printing with the large flat top side on the bottom, and use no supports. The only overhand is the small portion of the wheel hub and that tends to do well because of the slight slope.
Best of Luck!