Panda Building Blocks

MembershipPrimary Commercial License 本套积木由 122 块积木块组成。为方便在 3D 打印后进行组装，每个凸粒上都标注了数字用以示意安装顺序。。This set of building blocks consists of 69 pieces. To facilitate assembly after 3D printing, each stud is marked with a number to indicate the installation sequence. 打印前准备工作Preparation Before Printing清洗打印板，并均匀喷上胶水，以防止较小积木块在打印中脱落。如有烘干箱，建议对耗材进行烘干处理，因为受潮的耗材可能会导致榫卯结构出现轻微变形，从而使得积木难以插入。Clean the printing plate and spray glue evenly on it to prevent smaller building block pieces from detaching from the printing plate during the printing process. If there is a drying oven available, it is recommended to dry the printing consumables, This is because the damp consumables may cause slight deformation of the mortise and tenon structure, making it difficult to insert the building blocks. 打印后处理工作Post-printing Treatment仔细辨认凸粒上的数字，并按照数字将积木进行分类摆放。为了区分方便，数字6、8、9的右侧加注了小圆点。Carefully identify the numbers on the protruding grains, and classify and place the building blocks according to the numbers. For the convenience