Panda II. HueForge

Picture source/author: Kathryn Diane Nicholson Booth Then used HueForge v0.9.3 to create the model.   Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.24mm and the Actual Depth is 2.24mm. It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.   Filaments Used: PLA Anycubic Black Transmission Distance: 0.3 PLA Sunlu Meta Grey Transmission Distance: 3.5 PLA Elegoo Basic White Transmission Distance: 7 This print uses 3 unique filaments Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Grey At layer #14 (1.2mm) swap to White for the rest.