Panda Touch P1S Flush Mount Replacement Backplate

I made this so I can mount the Panda Touch on the front along with my flush mount for the original screen. It uses the hardware from the original backplate (magnets, screws, charging PCB). I used mounting tape (found here) to stick it onto the printer. Steps to install:Unscrew the charging PCB from the original backplate and install it onto the new backplate exactly how it was on the original, avoid screwing it in to tight because it screws into the plastic.Take a small allen key or anything else small and place the original backplate on an elevated surface with a hole, position the magnet(s) above the hole and push the magnet(s) out with your desired tool. Might require a hammer or something similar.Using a lot of force (with either a solid material or a vice) put the magnets into the new backplate. Double check the orientation of the magnets using the screen before installing as you will have to destroy the new backplate to get the magnets out.Grab your nearest bottle of super glue,