Panduit Mini-Com modular 2 port insert CHF2M

SummaryThis is a loose reproduction of Panduit CHF2M, which allows 2 mini-com modules to be installed in 1/3 modular wall plate. I had to make the tabs very rigid to stop them from breaking off. Depending on the position you are installing it in, it is sometimes possible to start at an angle and rotate the module into place which makes it easier to get it snapped into position. If you have to snap it straight in, it's possible, you just have to press very hard. Same for un-installing the module, it's possible, but not easy or fun. For me this "semi-permanent" installation is okay since I am not taking them apart frequently and I would prefer durability and strength over ease of installation. Edit: I uploaded a version 2 where I have tweaked the design and tolerances slightly so that the module is easier to snap in but still snaps securely. The difference between the two versions is very small, but I think the v2 version is slightly better. I am printing in PLA+ on an X1