Panel Lock

This lock is for a 18mm panel. If you want to use it on a 12mm panel use the parts with the "_short" extension in the name

Drill 20mm hole in panel
push part #1 through hole
push part #2 over part #1 and glue it to panel
push part #3 through
put part #4 on the end of part #1
glue part #5 as a stop on part #1



Some parts might be a tight fit (especially parts #2 and #5) to have a clamping effect, so a bit of pressure should do the trick to get them in place.

There's always room for improvement, so any suggestions are welcome