PAP Tinox Paramotor Battery Box

This is a LiFePO₄ battery box designed for the PAP Tinox v1 paramotor. It may fit other PAP paramotors, but it was specifically designed for my MY22 motor. All components from your original PAP battery box are required. I added an XT60 battery connector to make future battery changes easier, which requires cutting and soldering wires. If you prefer not to modify the wiring, you can add a negative rectangular cut in Bambu Studio to create slots for the wires to slide in and out. Keep in mind this will reduce the strength of the box. I printed mine in PETG, but nylon, ABS, ASA would work too. PLA is not recommended. Please be aware of the differences between LiFePO4 and LiPo. Running these batteries without a battery management system (BMS) can be dangerous. Required Additional Parts: M3x8x5 Heat Set Inserts Optional Parts: 30amp Fuse Holder Waterproof Plug XT60 Connector <a target="_blank" rel=