Paper Towel Holder

This is a remix of a remix. I have made 2 main changes:

1. I have split the holder ends into 2 parts each that interlock together. This is to increase strength since there are no longer any big vertical sections that have to be printed.
2. Added a version that supports a smaller tube diameter. I found that some of the paper towel brands have a slightly smaller diameter tube (about 35mm instead of 40mm) which made it impossible to use.

For both sizes, you'll need to print the following:

- 1 x Paper_Towel_Holder-Tab_Plate.stl
- 1 x Paper_Tower_Holder-Screw_Plate.stl
- 1 x TowelPart4_fixed.stl (found on source project 4459689)
- 1 x Endkappen.stl (found on source project 4459689)

Then, decide if you want the 40 or 35mm diameter version. Honestly, I think it's better to go with the smaller regardless.

**40 mm (larger diameter)**
- 2 x Paper_Tower_Holder_End_40mm.stl
- 1 x Endstücke.stl (found on source project 4459689)

**35 mm (smaller diameter)**
- 2 x Paper_Tower