Thingiverse
Fashion
Go to Model
Paracord Shackle
458
Downloads
402
Likes
0
Makes
A 25mm shackle(15mm inside) for paracord bracelets, but should scale OK.
Borrows the ClickyBolt from my Thing here https://www.thingiverse.com/thing:2756547.
Designed to be printed flat without support, thus the offset in the crosspin to allow a flat surface. Picture is with 6 strands of #275, 3/32" (2.3mm) paracord, but 4 strand of standard #550, 5/32" (4mm) should fit well too.
(like 3d printing forums? I'm over at 3dprintingspace.com, it just started up, looking for more members)
Borrows the ClickyBolt from my Thing here https://www.thingiverse.com/thing:2756547.
Designed to be printed flat without support, thus the offset in the crosspin to allow a flat surface. Picture is with 6 strands of #275, 3/32" (2.3mm) paracord, but 4 strand of standard #550, 5/32" (4mm) should fit well too.
(like 3d printing forums? I'm over at 3dprintingspace.com, it just started up, looking for more members)
mobiobi also publishes on
172 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
