Paracord Spool Holder

Hi, this is a holder for Paracord or similar.
About 50 meters of Paracord can fit on there.
It has a 6 mm hole in the middle for the first end of the paracord.
You need:

1x Inner part (I printed this without support)
2x outer part (print with support)
2x M6x20 mm machine screw
2x M6 washers

The outer parts fit tight onto the inner part, you can press them carefully onto the inner part.
Before you screw the outer parts on, only screw the bolts into the inner part, so they can can cut their thread, then you can screw the whole thing together. Ready!

The slot in the outer part is for squeezing in the other end.

Tip: If you take a cordless screwdriver and hold the other side with a pen you can super easily roll up the paracord