Parallel marking tool scriber imperial units 16th"

This is yet another version which allows marking lines along the reference board edge incrementing in 1/16th of an inch. Can be printed in both PLA and PETG and both should be totally fine as the tool doesn't experience stresses while in use. On the photo you see it printed in PETG-HF red and white. Light and small still allows you to mark up to three inches distance from the edge. I am using 0.08 layer height and even with that finer resolution the print is done in about one hour while doing two colours at the same time. If you don't need the 1/16th inch increments, you could try 1/8th inch version by clicking on the image below. Thank you for checking them out!