Parallettes for Calisthenics

3d Printed Parallettes V3 These parallettes are designed around parallel bars that are 41.30mm or .8" OD (Outer Diameter). I have included the .STEP file for this model for easy resizing to a smaller bar using Fusion360 (Press Pull tool) and similar software. They also require M3x12 screws or other long screws if you use a wooden dowel for example PRINTING INSTRUCTIONS Print the legs x4 in PETG or ABS (ABS RECOMMENDED) Print with minimum 5 walls and 10-15% infill Print all other plates in TPU (You may be able to substitute the other parts for another material but superglue may be required.) ASSEMBLY In on each side of the bar 3/8" in from the edge, drill a 1/8" hole. (NOTE: THESE HOLES MUST BE ALIGNED ON BOTH ENDS SO THE LEGS LINE UP.) Push each leg on to both sides, taking care to ensure they are facing the correct direction (with chamfers facing out and the flatter looking side facing in) Push M3x12 screws into place and thread on the nut. Press on the end caps for each end. Snap the