Parametric Air Tank Clip

This scad file is design to allow building of customized clips for the plastic clippard air tanks used on FRC robots.

>>>
Certain model s of the white plastic tanks available to FRC teams have been known to explode if not mounted and handled correctly. At least one of these explosions was due to a hose clamp used for mounting being over tightened. As a precaution always insert the tank by sliding one end in versus snapping down through the clip. Also, different printers may have different tolerances and may print these smaller than designed which may put stress on the tank. Measure before you insert.
>

The idea is you can vary the base to offset the tank from center, also put holes for bolts in different place, and vary the thickness and height based on your needs.

Finally you can string several together and make a holder for multiple tanks. The three tank holder shown just barely fits on my prusa I3 if rotated (see the plated STL file)

TODO: Need to