Parametric Battery Holder

#Parametric Battery Holder

Fits *any* round battery *you* can dream of.

As I was in need for a simple battery holder for my 10S3P Pack, I designed this very simple holder.

3 different frames are provided, **left**, **right**, and **center** so you can extend the holder as much as you like.

###How to use

Open the design in Fusion and open the parameters for the design. Measure the Cell's diameter you want to use and enter the value. Print the *Fit-Checker* to see if the Cell will fit properly, adjust if necessary.

Fill in the other dimensions dependent on your needs, the design updates accordingly. I provided comments for the parameters.

###Printing

No supports are needed. The space between the tabs should be bridged

###Limitations

As the Fusion design is very simple, the connection logic will break for everything smaller than 3 cells wide. Hard-limit is therefore 2x3 Cells.

Feel free to modify, or request improvements

###Tiny Update - v1.1
I modified the FitChecker slight