Thingiverse
Tools
Go to Model
Parametric Bit Driver (hex 2mm to 10mm)
274
Downloads
153
Likes
1
Makes
Since i have not found any good driver for 4mm bits i made one myself. Done in OpenSCAD, source provided.
Inside is an hole for a magnet (4mm diameter, 2mmheight). Magnet should just hold by pressfiting, otherwise use glue.
Tolerances work well for Prusa MK2/MK3, but maybe you have to adjust.
**Edit:** you seem to like this one, so i made it parametric (including customizer support). You can now generate hex drivers for 2mm up to 10mm - including different magnet-sizes.
Inside is an hole for a magnet (4mm diameter, 2mmheight). Magnet should just hold by pressfiting, otherwise use glue.
Tolerances work well for Prusa MK2/MK3, but maybe you have to adjust.
**Edit:** you seem to like this one, so i made it parametric (including customizer support). You can now generate hex drivers for 2mm up to 10mm - including different magnet-sizes.
Crono also publishes on
17 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
