Thingiverse
parametric book display stand
door STEAM_Beans
15
Downloads
14
Likes
0
Makes
I made this book stand for my wife, so she can display her books properly at a fair.
Just enter the dimensions of the book (or other stuff like DVD-boxes etc.) and optionally adjust the height, width or angle of the stand to your taste.
You can also simply add a frame, so the stand is able to hold loose sheets of paper, like flyers.
Wall thickness when printing should not be less than the value for "t_wand" in the SCAD file.
You can print it without any support or infill.
In most cases the stand is rigid enough. If you still want to increase stability, simply drill a hole in the bottom, fill it with sand and close it again with hot glue.
Just enter the dimensions of the book (or other stuff like DVD-boxes etc.) and optionally adjust the height, width or angle of the stand to your taste.
You can also simply add a frame, so the stand is able to hold loose sheets of paper, like flyers.
Wall thickness when printing should not be less than the value for "t_wand" in the SCAD file.
You can print it without any support or infill.
In most cases the stand is rigid enough. If you still want to increase stability, simply drill a hole in the bottom, fill it with sand and close it again with hot glue.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
