Parametric Brick Maker: Any Size, Any Scale

Make any brick, any size! Want a giant one, go for it!Fully parametric brick generator using the standard 8mm stud-pitch system. Set width, length, height, and scale. Everything else adjusts automatically. Tune First!Before you start printing I suggest finding the tolerance that works best for your system. If you are printing your at a scale of 1, then there is a profile for a tolerance test of -0.15 to 0.15 which covers a good range of possible tolerances. If it is outside of this range you may need to generate new bricks with different tolerances.ParametersUse the Customizer panel (View > Customizer) in OpenSCAD:ParameterDefaultDescriptionW / L / H2 / 4 / 3Studs wide, studs long, plates tall (3 plates = 1 brick)SCALE1Size multiplier, works up to giant desk-toy scaleTOL0.0Tolerance offset in mm. (See tolerance test for tuning)BRIDGE_FINStrueAxis-aligned fins inside the bottom cavity that cut max bridge span from ~13mm to ~3mmPrint settingsNo supports needed. Print open-bottom face-dow