Parametric cable passthrough - one or more cables

This is a cable passthrough I designed for my work in progress 3d printer enclosure/fume hood. It is parametric, so the base 3mf is probably not going to be useful to you without customizing, as it was specced for a 19mm mdf and a power cable thickness of my aftermarket right-angle power cable for my p1s. Basically, grab your calipers, measure your material and cable thickness, and input parameters according to your needs. It supports multiple holes along the cut axis (or two axis, but I havent actually tried printing this and I imagine assembly is a bit finnicky.) Gotchas I ran into: If you're printing a passthrough for something like a surge protector, make sure the screw diameter is large enough for the plug-end to fit through. I had to use 44mm screw diameter for a european power strip, US plugs would obviously be able to go a bit smaller in most cases because they aren't nearly so chonky. I print a lot with the 12mm fine profile, so that's the default. At that profile the alignmen