Thingiverse
Parametric customizable pipe cap (OpenSCAD)
door andreidescult
58
Downloads
45
Likes
1
Makes
This is an alternate pipe cap end design for OpenSCAD, which can be customized according to your need.
- full, single cap - measure closely to your inner diameter
- split cap, fix with screw - allow a bit more tolerance.
The split cap will fix very firmly with a proper screw. Look out in OpenSCAD when rendering, for a hint about the minimum screw length.
- Suitable for a wide range of sizes
- Customizable
- Fix firmly (split variant)
- Easy to remove (depends on tolerance to inner diameter)
- Easy to print (no supports)
- Screws from M3 to M8, several screw head models.
- full, single cap - measure closely to your inner diameter
- split cap, fix with screw - allow a bit more tolerance.
The split cap will fix very firmly with a proper screw. Look out in OpenSCAD when rendering, for a hint about the minimum screw length.
- Suitable for a wide range of sizes
- Customizable
- Fix firmly (split variant)
- Easy to remove (depends on tolerance to inner diameter)
- Easy to print (no supports)
- Screws from M3 to M8, several screw head models.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
