Thingiverse
Parametric Door Stopper
von bardiir
6
Downloads
2
Likes
0
Makes
A customizeable door stopper to be printed out of some soft material.
If you set your slicer to not cover up the vent hole with top/bottom layers and choose a somewhat open internal structure then you can seriously slam your door into this without it bursting open :)
If you set your slicer to not cover up the vent hole with top/bottom layers and choose a somewhat open internal structure then you can seriously slam your door into this without it bursting open :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!