Thingiverse
Parametric E3D clone Cooling Fan and (double) Part Blower
door nmaggioni
198
Downloads
92
Likes
2
Makes
**EDIT: superseded by the [V3 mount](https://www.thingiverse.com/thing:1531997)!**
An OpenSCAD version of the mount listed in the remix's sources.
This version has an easily configurable heatsink diameter (**heatsinkDiameter**) and side fan doubling (**doubleSideFan**). If you vary the heatsink diameter, there's a parameter for fine-adjusting the clamp's arms length as well (**clampLength**).
*Suggested minimum and maximum parameter as included in the source.*
The provided STLs are compiled for a 25mm heatsink, with respectively one and two side fans.
*EDIT 30/04/2016:* Customizer fixed.
*EDIT 11/01/2016:* added the configurability for a z-probe adjustment screw on the side for the [Micromake E3D mount][1], editable via the **zProbeScrew** and **zProbeScrewHeight** parameters.
[1]: https://www.thingiverse.com/thing:1025098
An OpenSCAD version of the mount listed in the remix's sources.
This version has an easily configurable heatsink diameter (**heatsinkDiameter**) and side fan doubling (**doubleSideFan**). If you vary the heatsink diameter, there's a parameter for fine-adjusting the clamp's arms length as well (**clampLength**).
*Suggested minimum and maximum parameter as included in the source.*
The provided STLs are compiled for a 25mm heatsink, with respectively one and two side fans.
*EDIT 30/04/2016:* Customizer fixed.
*EDIT 11/01/2016:* added the configurability for a z-probe adjustment screw on the side for the [Micromake E3D mount][1], editable via the **zProbeScrew** and **zProbeScrewHeight** parameters.
[1]: https://www.thingiverse.com/thing:1025098
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
