Parametric Electrical Box Plate Generator!

This is a script that can generate essentially any custom wall plate you might need. It supports up to 6 gangs, and each gang is customizable. There are options for Duplex, Toggle Switch, Decora, and Blank. The outer dimensions of the plate is set to standard dimensions by default, but there's a toggle button you can use to adjust the outer dimensions, allowing you to make custom plates that are as jumbo as you need. So don't worry if the carpenters left a 10 inch hole around an electrical box. Print a 10 x 10 cover for it lol. PAY ATTENTION There is a toggle button to “Make the back concave”. This hollows out the back of the cover, making it shaped like an actual plate rather than a flat slab. This is great because it allows you a little more wiggle room if your receptacles are sticking slightly too far out. BUT, this means you have to print the face of the cover face down on the bed, which will give you a textured finish. If you don't care, then use this option. FAIR WARN