Parametric Eurorack Bracket

Here is an experimental bracket for a Eurorack modular synthesizer. It works nicely with my Parametric Eurorack Rail but there are enough variables to change that perhaps you can get it to work with some other rail system. By adjusting the "tiers" parameter, you may create a 3U or 6U bracket. Each tier has a parameter determining the angle of each tier relative to the base.

ATTENTION: This design is provided for experimental and fun purposes only and has not been rigorously tested. If you have any qualms whatsoever about mounting your expensive synthesizer hardware to a pile of cheap plastic, I advise that you do not use this.

Printing is fairly straightforward. I recommend a fairly dense print, as a heavier bracket will be more stable. The provided default values should produce a 6U bracket that just barely fits on a Prusa i3 MKii when rotated this way or that. Your mileage may vary.