Parametric Fidget Spinner

Before you print:This model is fully parametric (you can modify it to your liking). You may need a brim on the edges of the spinner bodyPlease refer to the BOM for additional parts Bill Of MaterialsPart NameQuantity required(printed) Fidget Spinner body1x(printed) Bearing Insert6xF695 Ball bearing (non shielded for low friction)6xPrinting TipsHigh infill will increase the inertia of the part (if your crazy, tungsten PETG is an option)Supports are required (you should dial in your settings with low infill test prints)Warping should be avoided Use a “fine” profile for best ergonomics (0.08mm layer Height not required)AssemblyOnce you have all the parts ready, you can press the bearings into the body (flange outside)Note: you may need glue if the bearings are looseyou may press in the bearing inserts (may require force)Safety precautionsThis fidget spinner shall never be spun with any power tool or air hoseRotational speed should never exceed 3000 RPM Keep away from face and eyesUse Commo