Parametric Hand Tool Organizer

This is an organizer or holder for pliers, scissors, crimpers, wire cutters, etc.

Note: Customizer can't deal with the 2D array. Build in OpenSCAD directly. The samples are just to view on the site.

Any print settings. No rafts or supports.

The edge screws are half holes so that multiple designs can be places together by sliding the next one under the screws of the last one.

The scissors pic is to give an idea of how to measure.
The bottom edge is 90mm, but increases with larger tools, so a bit more for larger tools actually.

The 4 parameter array per tool:
The top size is the width of the tool where you want it to stop, but more as the angle increases (larger tool).
Bottom size is large enough for the tip end 90mm from the top.
Width is the H width of the slot. Add at least 2mm and measure the largest area of the tool where it will stop and below.
Overhang is extra spacing, like the width of handles past the stop.