Parametric IKEA SAMLA Wedge NG

This is a parametric remix of [IKEA Samla Tray Insert Wedge NG](https://www.thingiverse.com/thing:3572388) by iggyggi.

#### Summary of the original design

> This is a minor upgrade to the "IKEA Samla Insert Wedge" by Dvogonen.
>
> Its basic purpose is to push the small ends of the Samla tray insert apart, to prevent it from slipping over the notches down into the Samla box.
>
> With the original design, I could not reliably get a double sided tape to stick onto the tray, so I designed a version with two 5mm holes. Use them as guides to drill holes of the same diameter into the tray and use either screws or a zip-tie to fasten the wedges in the tray.
>
> There is also a cutout to save some material.
>
> I printed in PLA with 2 perimeters and 10% infill. The part is mostly compressed from the side, so it should be sturdy enough.

#### Thingiverse



#### GitHub