Thingiverse
Parametric Kossel-like delta 3d printer frame support rods
por ernisv
0
Descargas
1
Likes
0
Makes
M5 threaded support rods for delta printer to improve frame stiffness.
Hardware needed per one side:
* 2 M5 rods,
* 4 M5x10 bolts,
* 12 M5 nuts,
* 4 M5 T-nuts for 2020 extrusions.
Rod mounts are symmetric, so you should just print 4x of them for one side.
OpenSCAD file is parametric, you could enter a rectangle dimension that your support rods would form and depending on that it would produce correct angle of cross-rod part.
Hardware needed per one side:
* 2 M5 rods,
* 4 M5x10 bolts,
* 12 M5 nuts,
* 4 M5 T-nuts for 2020 extrusions.
Rod mounts are symmetric, so you should just print 4x of them for one side.
OpenSCAD file is parametric, you could enter a rectangle dimension that your support rods would form and depending on that it would produce correct angle of cross-rod part.
ernisv también publica en
33 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
