Thingiverse
Parametric Macro Pad
von ctheroux
3
Downloads
6
Likes
0
Makes
This is a parametric macro pad using a Pi Pico. It uses Cherry MX compatible switches.
You'll need a few drops of glue to mount the switches plate on the enclosure. As shown in the pictures, keep the 4 switches loose until you screw the Pi Pico on the enclosure. 4 M2 x 5mm screws are required.
The firmware can be found at https://github.com/ctheroux/MacroPadFirware.
Take a copy of MacroPad4x4Parameters.scad, modify it according to your macro pad and render it. You should not need to modify the other files.
Support material is not required on the build plate only. An infill of 20% is recommended.
This object's main web page is: http://www.ctheroux.com/parametric-macro-pad/.
This object was designed using openSCAD.
You'll need a few drops of glue to mount the switches plate on the enclosure. As shown in the pictures, keep the 4 switches loose until you screw the Pi Pico on the enclosure. 4 M2 x 5mm screws are required.
The firmware can be found at https://github.com/ctheroux/MacroPadFirware.
Take a copy of MacroPad4x4Parameters.scad, modify it according to your macro pad and render it. You should not need to modify the other files.
Support material is not required on the build plate only. An infill of 20% is recommended.
This object's main web page is: http://www.ctheroux.com/parametric-macro-pad/.
This object was designed using openSCAD.
ctheroux veröffentlicht auch auf
406 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
