Parametric Modular Model Rocket — Fin Can

How to Customize This Model This model is fully parametric. Every dimension can be changed directly in MakerWorld Customizer or in OpenSCAD. Here is what every parameter does and what values to use. BODY DIAMETRO_CORPO — outer diameter of your rocket body tube in mm. This must match exactly the body tube section you are using. Default: 35mm. Common values: 29mm / 35mm / 40mm / 54mm. H_CODA — total height of the fin can section in mm. Make it taller if you want fins higher up on the body. Default: 80mm. SPESSORE — wall thickness in mm. Do not go below 2mm. Default: 2.5mm. MOTOR DIAMETRO_MOTORE — inner diameter of the motor tube in mm. This must match your motor exactly. → 18mm = Estes A8 / B6 / C6 → 24mm = Estes D12 / E12 → 29mm = larger composite motors THREADED CONNECTION H_CONNETTORE — length of the male threaded connector that plugs into the body tube above. Default: 20mm. Increase if connection feels weak. TOLLERANZA — gap between male and female thread in mm. Default: 0.2mm for pr