Parametric pot lid holder

This model will help you put an end to pot lids laying around, never stacking, and falling as soon as you open the cabinet doors.Pot Lid HolderNo two lids are the same and this model was designed so you can adapt to the diameter, edge thickness and height/curvature of each of yours. Unfortunately, this means a bit of trial and error will probably be required on your part but some photos and guidelines are provided below to help you.It can be attached with a single screw to cabinet doors (no adhesive tape given the weight of lids and the forces applied when opening/closing cabinet doors). Sizing GuidelinesThe 2 main parameters are “arm length” and “clamp width”. The arm length should be a bit greater than the radius of the lid it will hold. This helps keep the center of the lid below the screw so the lid is held firmly against the cabinet door. That way, opening the door should not result in the lid banging against it (assuming the clamp fits, see below). The clamp width corresponds to