Thingiverse
Parametric springloaded battery mag
von nazimovmaxim
3
Downloads
1
Likes
0
Makes
Spring
1. aaa6_mag_spring should be printed in PETG.
2. aaa6_mag_spring can be stretched or compressed manually if needed.
3. Z-seam on aaa6_mag_spring should be placed in the corner.
Case
1. The aaa6_mag_case may be printed in PETG, though I recommend PLA due to its rigidity
2. Cooling as low as possible for aaa6_mag_case. This will ensure the best layer adhesion.
No special settings for aaa4_vase_mode.
1. aaa6_mag_spring should be printed in PETG.
2. aaa6_mag_spring can be stretched or compressed manually if needed.
3. Z-seam on aaa6_mag_spring should be placed in the corner.
Case
1. The aaa6_mag_case may be printed in PETG, though I recommend PLA due to its rigidity
2. Cooling as low as possible for aaa6_mag_case. This will ensure the best layer adhesion.
No special settings for aaa4_vase_mode.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
