Parametric tape roll organizer

This is a multi-tape holder thingy. I started out with a cable holder I downloaded years ago, and there was no name on it. It works best hanging, but could probably work on its side.

Most of the parameters shouldn't need changing except the slot size list. Each slot should be about 1mm larger than each tape roll you measure. The screw holes are in the 2nd slot and 2nd to last, so those should be large enough for a screwdriver to fit, but can be anywhere and as many as you want. It works best with taller rolls toward the middle though, so they're easy to grab. The nubs on the ends should hold the tape in place if you don't go over ~3mm larger than the roll width.

Easy print. 0.2mm layers and no supports. Can be longer than the bed width if you rotate diagonally.