Parametric Vertical Splined Planter Pot

***Edit - V3 parametric model fixed a few bugs in the parametric model on the base and drain holes.*** Very large sizes created a slightly off-center hole. This should correct that. Same rules - make small changes, click OK to set those parameters. Repeat until you have something you like. If you get an error and have not recently clicked “OK”, you'll have to click OK and then undo and you'll lose all changes until the last “OK” click. This is my second parametrically-generated planter pot and parametrically-generated matching drip tray. Before you print this model and to avoid wasting time and/or filament, read this completely before you proceed. For this model, you can change the height, width at the top (RADIUS), width in the middle (RADIUS), width at the bottom (RADIUS), number of splines, width of the splines, depth of the splines, pot wall thickness, drain hole diameter, height of the center bulge, and the overall height of the drip tray. Note the drip tray uses the law o