Thingiverse
Parametric Vice Jaw Cover
door goth2k
19
Downloads
9
Likes
0
Makes
Parametric Vice Jaw Cover.
To use it open Ganasce.scad with OpenSCAD and you can play with the parameters below to change the dimensions of the Jaw Cover:
vw: width of the vice
vd: depth of the cover
vh: height of the cover
th: thickness of the cover
gap: air gap to allow on each side of the cover width
Please note, the attached STL file is based on to the default values and it will produce a Jaw Cover for a Vice Jaw large 50 mm.
To use it open Ganasce.scad with OpenSCAD and you can play with the parameters below to change the dimensions of the Jaw Cover:
vw: width of the vice
vd: depth of the cover
vh: height of the cover
th: thickness of the cover
gap: air gap to allow on each side of the cover width
Please note, the attached STL file is based on to the default values and it will produce a Jaw Cover for a Vice Jaw large 50 mm.
goth2k publiceert ook op
40 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
