Thingiverse
Parasect
20
Downloads
13
Likes
0
Makes
#047 Parasect
Multicolor!
It's easier to print than it looks and also to clean. The hardest parts are the legs. Make sure you have a good first layer and use brim.
!!! In the slicer, move the model 1-2 layers down (Z-0.2-0.4) so that all feet are flat on the plate..
Check out my 18 hours print :D (only 2 colors)
https://www.youtube.com/watch?v=hLBR2PNo7V4&list=PL1OsNQIDlo4uQpxiUHadn-uWuHNYxWLdQ&index=18
Multicolor!
It's easier to print than it looks and also to clean. The hardest parts are the legs. Make sure you have a good first layer and use brim.
!!! In the slicer, move the model 1-2 layers down (Z-0.2-0.4) so that all feet are flat on the plate..
Check out my 18 hours print :D (only 2 colors)
https://www.youtube.com/watch?v=hLBR2PNo7V4&list=PL1OsNQIDlo4uQpxiUHadn-uWuHNYxWLdQ&index=18
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
