Parkside x20 Battery case

This is a battery case for Parkside x20 machines , for 18650 batteries and circuit board... or 150 grams of sugar sweetener XDXDXD

there's no need for supports, the model was prepared for "bridges".
not intend to be a replica of original case , this was made to be simpler to print.and diy.
.
note:glue the tip end of the CLIP in its specific place.
.
for mini voltmeter model use one in foto , very common (fits great no glue required)
probably its better to mount a test button to check the voltage (there's a determined place for it just need to cut the hole)
.
.
the Parkside batteries are fairly cheap to get ,making a battery will probably get more expensive than 17 euros.
.
Notice!! In order to work in the parkside machines besides plus and negative you must use a 10k resistor between the negavive and the (T) terminal (to by-pass the termistor)
Use a bms to control the charge

UPDATE : 31/10/2020
More models available up to 5x3 cells
I update the TOP part to a ne