Part Cooling with Neopixel

**Info**
This is a part cooling system made by [this guy](https://www.thingiverse.com/thing:4211824) along with my approach on hotend Neopixels.

**You will need**
- 5 Neopixels similar to this one - [Single Breakout Neopixel](https://www.banggood.com/50Pcs-DC-5V-3MM-x-10MM-WS2812B-SMD-LED-Board-Built-in-IC-WS2812-p-963382.html?utm_source=googleshopping&utm_medium=cpc_organic&gmcCountry=GR&cur_warehouse=CN)
- a motherboard that can support Neopixels
- Soldering Iron
- a 3-wire ribbon cable with a connector to fit your motherboard
- ready to tweak some firmware stuff
- Insulation tape

**Installation**
- On the blower side, you screw it to your blower fan, the same way the stock blower vent is installed.
- On the other side, it holds to the fan box with a small chamfer, make sure to slide it in.
- The leds are seated into their slots and then soldered with small wires . You can even hot-epoxy glue them to the printed but, but this makes it impossible to transfer them to