Thingiverse

Part Fitting Calibration

von MEH4d

9.2k Downloads

5k Likes

45 Makes

Zum Modell

Do your print-in-place bearings, joints, hinges..etc, stick together on you ?
Do you have nuts/bolts, screw threads, pegs and holes or gears that were supposed to fit and they don'?t?
Well, those days are over after you run through this calibration for part fitting!

calibration ESteps extruder extrusion fitting Flow holes Part Fitting pegs S-Plugs stick together thin wall width calibration ESteps extruder extrusion fitting Flow holes Part Fitting pegs S-Plugs stick together thin wall width calibration ESteps extruder extrusion fitting Flow holes Part Fitting pegs S-Plugs stick together thin wall width calibration ESteps extruder extrusion fitting Flow holes Part Fitting pegs S-Plugs stick together thin wall width calibration ESteps extruder extrusion fitting Flow holes Part Fitting pegs S-Plugs stick together thin wall width calibration ESteps extruder extrusion fitting Flow holes Part Fitting pegs S-Plugs stick together thin wall width calibration ESteps extruder extrusion fitting Flow holes Part Fitting pegs S-Plugs stick together thin wall width calibration ESteps extruder extrusion fitting Flow holes Part Fitting pegs S-Plugs stick together thin wall width

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Warum?

Print-in-place-Design

Print-in-place Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker