MakerWorld
Organizers
Go to Model
Parts holder
1
Downloads
1
Likes
1
Makes
I design this here with the goal of storing parts I needed an organizer so here it is its holds 3 hots ends, extruding unit and then small parts like grease, screws, socks or whipers the pictures is what im storing in it and there is much room to move things between them,in the pictures you may see there is a red part, that failed due to warping but it shows it can hold a hot end with fani printed in PLA generic no issues with two prints on a 0.4mm nothing special as i rarely design parts but it works well
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
