Pass Through Conduit

I have several locations in my home where I need to pass cables through an opening in a wall or cabinet. Rather than leave the exposed drywall, wood, etc I like to clean them up with these handy two-piece conduits. Slide the large piece through one side then snap on the smaller piece from the opposite side. You can also use the larger piece alone with some glue for situations where you can't easily access the back side.

The layers of the print actually act almost like the ratchet notches on a zip tie to retain the clip. Once installed and snugged up you're left with a very clean conduit through the wall or panel. The print is thin enough that the side walls are basically solid so you cna even trim or sand to exact thickness if desired.

This particular model is best suited for a 10mm thick panel or wall with a 1-3/8" hole (adequate to fit most grounded power plugs through)