Thingiverse
Pasta Cutter Remix
door Aerotronic
29
Downloads
34
Likes
0
Makes
Hi,
Just a remix of the good design from MEH4d !
Made the handle longer (100mm), and worked on clearances and tolerances
To print the rolling cutter, i suggest you, when you put the part in your slicer, to split it at the half of tickness (4mm), conserve two parts, and return the lower part (as shown in screen capture).
So you print 2 halfs parts and glue them. I did it succesfully !!!
If you are a pasta maker, have a look to my Pasta Dryer here :
https://www.thingiverse.com/thing:4346209
Compact when stocked, with 10 levels of 20cm.
Have fun
Just a remix of the good design from MEH4d !
Made the handle longer (100mm), and worked on clearances and tolerances
To print the rolling cutter, i suggest you, when you put the part in your slicer, to split it at the half of tickness (4mm), conserve two parts, and return the lower part (as shown in screen capture).
So you print 2 halfs parts and glue them. I did it succesfully !!!
If you are a pasta maker, have a look to my Pasta Dryer here :
https://www.thingiverse.com/thing:4346209
Compact when stocked, with 10 levels of 20cm.
Have fun
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
