Patio Heater Shelf

This is a quarter shelf designed to fit around the center pole on a patio heater. Every time I turned the heater on it irritated me that I didn't have anywhere close by to put down my drink or a cigar, so now I do.

Print 4, then bolt the quarters together with 5mm x 16mm bolts.

If it isn't already you need to flip it so the tall sides are up or the print time doubles from extra support height. Expect around 10 hours per shelf quarter.

Printing notes:
1.2mm wall thickness
10% infill
Supports everywhere, Support Density 7

Additional notes.
- I have included the Fusion file so go nuts.
- I plan to design cigar rests to drop into the weep holes in the bottom of the shelf. Hopefully I will get those done before this weekend.