Thingiverse
Patio Swing Canopy Screw - M8 threaded
0
Downloads
0
Likes
0
Makes
M8 threaded screw with knob for outdoor patio swing to mount the canopy.
Printed in Elegoo PLA+ @ .22mm layer height, 210c, 60c bed. Probably way overkill but 10 vertical/horizontal shells at 1mm thickness and 100% infill. It was printed in knob down orientation with no supports but would likely be best printed sideways if possible for better strength. Standard M8 thread, total length is 55mm.
Printed in Elegoo PLA+ @ .22mm layer height, 210c, 60c bed. Probably way overkill but 10 vertical/horizontal shells at 1mm thickness and 100% infill. It was printed in knob down orientation with no supports but would likely be best printed sideways if possible for better strength. Standard M8 thread, total length is 55mm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
