Thingiverse
Patton - Fender Extender
von Rawnei
6
Downloads
9
Likes
1
Makes
2023-08-07: Did some refinements on the extender, the old design could sometimes fold up and get stuck in the tire when doing things like riding down stairs or jumping so I made it a little bit longer, changed the angle a bit and added a small rounded feature at the end to make it much less likely to happen.
A fender extender for the Patton.
The fender on the Patton stops pretty short and allows for water and dirt to spray up and behind meaning that it does a poor job of what it's supposed to be doing.
This is a simple extender that adds quite a bit of protection and stops water and dirt from spray upwards and to some degree backwards.
Install using strong double sided foam tape such as 3M VHB tape, make sure the surface area of the fender is clean and de-greased first, soap is good enough for cleaning the fender. Before attaching permanently check the fit by hand, it should be pretty easy to install.
Print in TPU95A and make it solid (100% walls/infill).
A fender extender for the Patton.
The fender on the Patton stops pretty short and allows for water and dirt to spray up and behind meaning that it does a poor job of what it's supposed to be doing.
This is a simple extender that adds quite a bit of protection and stops water and dirt from spray upwards and to some degree backwards.
Install using strong double sided foam tape such as 3M VHB tape, make sure the surface area of the fender is clean and de-greased first, soap is good enough for cleaning the fender. Before attaching permanently check the fit by hand, it should be pretty easy to install.
Print in TPU95A and make it solid (100% walls/infill).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
